Weidmuller PTX800A - Configurable counter and totalizer Manual de usuario descargar pdf (Pagina 37)

• Installation

Caution: In order to meet product safety requirements, these units must

only be installed, by qualified staff, in accordance with the information

given in this manual, using the mounting clips and terminal blocks

supplied, and all relevant national electrical wiring and safety rules

must be followed.

Locate the instrument in an area that is free from dust, moisture

and corrosive gases (pollution degree II or better). Do not cover the

ventilation holes at the side of the case.

wer Supply Requirements

Check the power supply against the model number before applying

power to the instrument. PTX800A displays must be used with a

suitable mains Power Supply, ratings are as follows:

Voltage Range Nominal Voltage Power Frequency

100–132 V AC 110 V AC 6 VA 47-63 Hz

200–264 V AC 240 V AC 6 VA 47-63 Hz

21.6–26.4 V DC* 24 V DC 6 W (at 24 V DC) -

*The 24 V DC rated model has cULus approval. File number E256486.

Digital pulse output

The retransmit pulse output gives a single pulse every time the total

creases by one unit. The pulse width is a constant 32 ms and the

minimum off time is 32 ms. The output is an isolated, NPN, open

collector transistor type and can switch a maximum of 50 V DC or a

current up to 200 mA.

Reset pulse input

Accepts a volt-free contact closure, or a shorting link, between pins

7 a

nd 12. The contact must be closed for at least 100 mS.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

Sin comentarios

Weidmuller PTX800A - Configurable counter and totalizer Manual de usuario Pagina 37