Weidmuller PTX800A - Configurable counter and totalizer Manual de usuario descargar pdf (Pagina 30)

Changing the setup options

Use setup mode if you have to change a setting or calibrate the

outputs. The setup mode stops all operation. As soon as you have

setup the last parameter, the unit behaves as if it has been switched on

with the new settings. This does not mean that the total is reset - you

must do this yourself if necessary.

If you want to abandon all the changes you have made, simply remove

the security link (or remove the power) before the save message is

shown.

To change the instrument setup:

1. Connect the security link (short pins 8 & 9).

2. P

ess the PGM key.

The setup sequence is shown in the table on page two.

• Setup options

General

There are four basic areas of the instrument operation that must be

setup on a fully configured PTX800A. They are:

• An

alogue Current/Voltage inputs;

• Display and keypad operation;

• Alarms one and two (optional); and

• Analogue outputs (optional).

You can disable the alarms and/or analogue outputs if you do not need

them (if so their settings will not be displayed).

ftware version

The information in this guide refers to versions 1.00 to 1.11.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Sin comentarios

Weidmuller PTX800A - Configurable counter and totalizer Manual de usuario Pagina 30