Weidmuller PMX420SERIES - Display instrument for control pane Manual de usuario descargar pdf (Pagina 25)

Procedure

When the

display shows

Action/Description

Put the instrument in setup mode and scroll through the main menu

CIPn

Press ì or Å

CIPy

Press ENT to select input calibration

Connect the current source and press ENT

0.00

Set the current source to 0.00 mA and press ENT

Press ENT

20.00

Set the current source to 20.00 mA press ENT.

Wait while the input value is processed.

Connect the voltage source and press ENT

0.00

Set the voltage source to 0.00 V and press ENT

Press ENT

10.00

Set the voltage source to 10.00 V press ENT.

Wait while the input value is processed.

COPn

Continue with the setup sequence.

Note: To discard changes to calibration and setup you can remove the power at this point.

Output calibration (PMX420Plus only)

Analogue Output Setup

1. Enter setup mode. Then remove the security link, press ENT and

then replace the link. The display will show a single digit (normally 1).

2. P

ress ENT again. The display will show OP=I (for current outputs) or

OP=E (for voltage outputs). Use ì to select the value you require, then

press ENT to accept. Continue through the setup mode. Note: you will

be required to calibrate the outputs (so follow the procedure below).

quipment requirements

• An accurate digital multimeter (accurate to 0.05 mV and ±0.1 μA)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 67 68

Sin comentarios

Weidmuller PMX420SERIES - Display instrument for control pane Manual de usuario Pagina 25