Weidmuller WI-MOD-E-G Manual de usuario Pagina 18
- Pagina / 28
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
18
Wireless Gateways—Product Data 900 MHz
WI-GTWY-9-DE1
DeviceNet Slave
WI-GTWY-9-M+1
Modbus Plus Slave
Technical Data
Power Supply
Current drain during radio transmission
I/O Capacity
Register Size
Number of remote WI-GTWY-9 addresses
General Data
Operating Temperature
Storage Temperature
Humidity
EMC Standards
Approvals
Mounting
LED indication
frequency hopping spread spectrum
Transmit power
Maximum line of sight range
Dimensions mm (in)
Wireless Communications
On-board I/O
Configuration
Diagnostics
Radio Transceiver
Frequency hopping spread spectrum
Transmit power
Receiver data sensitivity
Maximum line-of-sight range
Data rate
Antenna connector
Ordering Data
9 - 30VDC / 12 - 24VAC
Battery charging circuit included for 12V back-up battery, max
charge current regulated to 0.7A (>12V supply)
Normal current drain
MD1 version 12V 150mA; 24V 90mA
Other version 12V 270mA; 24V 170mA
Add 5mA per active I/O
Add 12V 350mA; 24V 200mA to above
512 bytes input and 512 bytes output up to 4300 discrete I/O
points, or up to 256 analog in / 256 analog out
16 bit
500
0 to 60°C (30 to 140°F)
0 - 95 %RH
EN 301 489, FCC Part 15, Approved to FCC Part 15.247,
RS210
Class 1 Div 2 (USA, Canada).
DIN rail mounting,
for processor OK, radio TX and RX, serial TX and RX,
active status
130 x 185 x 60 (5.1 x 7.3 x 2.4)
DeviceNet 2.0 Slave, optically isolated RS422 with selectable
baudrate between 125, 250 and 500 Kbit/sec.
Eight discrete I/O, individually configurable as input or output.
Inputs suitable for voltage free contacts.
Outputs are FET, 30VDC 500mA.
via free Windows software
on-line read/write of I/O registers, radio signal strength values
from remote units, and off-line testing of data bus protocol.
902-908 MHz, sub-bands configurable
1W
108dBm
USA/Canada, 4W ERP, 20+ miles
19.2 Kb/s with forward-error correction
SMA coaxial
Type Part No.
WI-GTWY-9-DE1 6720005024
9 - 30VDC / 12 - 24VAC
Battery charging circuit included for 12V back-up battery, max
charge current regulated to 0.7A (>12V supply)
Normal current drain
MD1 version 12V 150mA; 24V 90mA
Other version 12V 270mA; 24V 170mA
Add 5mA per active I/O
Add 12V 350mA; 24V 200mA to above
2048 bytes input and 2048 bytes output up to 4300 discrete
I/O points, or up to 1024 analog in / 1024 analog out
16 bit
500
0 to 60°C (30 to 140°F)
0 - 95 %RH
EN 301 489, FCC Part 15, Approved to FCC Part 15.247,
RS210
Class 1 Div 2 (USA, Canada).
DIN rail mounting,
for processor OK, radio TX and RX, serial TX and RX,
active status
130 x 185 x 60 (5.1 x 7.3 x 2.4)
Modbus RTU (binary), master / slave configurable. RS232 or
RS485, 300 - 19200 bits/sec.
Modbus Plus Slave, optically isolated RS485 with standard
baudrate of 1 Mbit/sec, global data base transactions with
routing for up to six networks.
Eight discrete I/O, individually configurable as input or output.
Inputs suitable for voltage free contacts.
Outputs are FET, 30VDC 500mA.
via free Windows software
on-line read/write of I/O registers, radio signal strength values
from remote units, and off-line testing of data bus protocol.
902-908 MHz, sub-bands configurable
1W
108dBm
USA/Canada, 4W ERP, 20+ miles
19.2 Kb/s with forward-error correction
SMA coaxial
Type Part No.
WI-GTWY-9-M+1 6720005025
Radio communications can be configured for combination
of event reporting (change-of-value), update time, read/write
blocks and poll response. Radio message includes system
addressing, unit addressing, error checking and configurable
security encryption.Communication control includes message
acknowledgments and up to four re-transmissions. Peer to
peer addressing. Messages may be routed through four
intermediate repeater addresses. Fail-to-transmit and fail-to-
receive alarms configurable
- Product Information 1
- Wireless Input/Output (I/O) 4
- WI-I/O 9-L-T 5
- Transmitter 5
- WI-I/O 9-L-R 5
- Receiver 5
- WI-I/O 9-L-P1 6
- WI-I/O 9-L-P2 6
- Set with 2 WI-ANT-DPL-0-8 6
- WI-I/O 9 Multi I/O Units 7
- WI-I/O 9-1 WI-I/O 9-2 8
- WI-I/O 9-3 9
- WI-I/O 9-4 9
- Typical Applications 10
- Features 10
- WI-I/O-EX-1-S-11 11
- WI-I/O-EX-1-S-12 11
- WI-I/O-EX-1-S-13 12
- WI-I/O-9-K 14
- Wireless Gateways WI-GTWY-9 15
- WI-GTWY-9-PR1 16
- Profibus DP Slave 16
- WI-GTWY-9-MD1 16
- WI-GTWY-9-PR2 17
- Profibus DP Master 17
- WI-GTWY-9-ET1 17
- WI-GTWY-9-DE1 18
- DeviceNet Slave 18
- WI-GTWY-9-M+1 18
- Modbus Plus Slave 18
- Wireless Data Modems 19
- WI-MOD-9-D 20
- Radio 900MHz 20
- WI-MOD-9-E 21
- Ethernet 900MHz 21
- WI-MOD-E-100 22
- Ethernet 2.4GHz 100mW 22
- WI-MOD-E-300 22
- Ethernet 2.4GHz 300mW 22
- GPRS Alarm Modem 23
- Accessories 24
- 12/07 • 7.5M • LIT0705 28
Relacionado con productos y manuales para Redes Weidmuller WI-MOD-E-G
Redes Weidmuller WI-MOD-E-G Manual de usuario
(114 paginas)
(114 paginas)
Redes Weidmuller WI-MOD-E-G Manual de usuario
(90 paginas)
(90 paginas)
Redes Weidmuller WI-MOD-E-G Manual de usuario
(4 paginas)
(4 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.051 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales