Weidmuller UHZAR - Universal glavanically isolated signal con Manual de usuario descargar pdf (Pagina 20)

• Installation

These units must only be installed by qualified staff in accordance with

the information given in this manual and all relevant national electrical

wiring and safety rules must be followed.

Locate the instrument in an area that is free from dust, moisture and

corrosive gases.

Connections

For effective protection from electromagnetic noise, all signal cables

must be shielded, or located on conductive trays or in conduits.

Use 12-28 AWG Cu Wire rated for temperatures above 70 °C Only,

tighten to 4.5 lb-In. Strip wires to 7 mm from the ends. Use a suitable

ferrule for multi-stranded wires (do not solder).

Terminal Signal

1 12 V DC (out)

Input signal/sensor

2 Pull Up/Down

3 0V

4 Signal +

5 Signal −

6 High voltage Signal +

Analogue outputs

Analogue

Output type

OP=I

OP=E

Current based output

Voltage based output

Toggle Accept

Analogue output

range

OPL=

4.00

Output low value

e.g., 4.00

Dec

Inc

OPH=

20.00

Output high value

e.g., 20.00

Dec

Inc

Output action

OP=d

OP=r

Direct

Reversed

Toggle Accept

Calibrate

Output?

COPn

COPy

Skip output calibration

Calibrate outputs

Toggle Accept

Setup Sequence (continued)

1 2 ... 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Weidmuller UHZAR - Universal glavanically isolated signal con Manual de usuario Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Weidmuller UHZAR - Universal glavanically isolated signal con