Weidmuller AI8 - Multi channel signal transmitter Manual de usuario Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 36
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
27
Adjusting the alarm setpoints
To change a setpoint, press the ENT key when the value is on display.
Use the
& and ^ keys to change the value and press the ENT key to
save.
Note: There are limits for the setpoint values that depend on the input
range setting and you cannot change the value if setpoint security is
on.
• Setup mode
You can set all the programmable variables from the front panel using
setup mode. Alternatively, if the unit has the digital communications
interface fitted, you can use a PC connected to the unit. The Run
mode section describes how to put the unit into setup mode.
PIN Numbers
There is a sub-menu that allows you to change the user PIN numbers.
In most cases you should leave defaults unchanged. Otherwise if you
loose the numbers you will have to return the unit to the factory.
ENT
EXIT
EXIT
EXIT
ENT
ENTEXIT
EXIT
This screen allows you to select measured
variab es for use n caculated values
Sets the number of samples o take
when measur ng each nput (1 10)
Sh ft se ector to p evious measured value
EXIT
Save select ons
ENT
Togge Yes/No
Sh ft selector to next measured value
Raise Number
ENT
Accept Value
Lower Number
Setup Mode
Prev Next
Measured Variable Selection
To Run Mode
Setup P.I.N
100
Default PIN = 100
Lower PIN
1Y 2Y 3N 4Y
5N 6Y 7Y 8N
Input 2
Prev Next
Input 7
Prev Next
Input 5
Prev Next
Input 4
Prev Next
Input 3
Prev Next
ENT
Input 1
Prev Next
Input 8
Prev Next
Input 6
Prev Next
Output Setup
Prev Next
P.I.N Setup
Prev Next
Display Setup
Prev Next
Comms Setup
Prev Next
Alarm Setup
Prev Next
ENT
Input Setup
Prev Next
User’ Definition
Prev Next
Save changes to E²PROM? Otherw se
value wi l be used unt l next power up
Togge
ENT
Accept Value
Save Options
Save ?
Yes
Continue ?
No
Continue ?
Yes
Number of Sample
1
ENTEXIT
Raise PIN
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Comentarios a estos manuales

Sin comentarios