14
1 General instructions
The WAVESERIES signal conditioner PT 100 should only be
installed by qualified staff. The signal conditioner PT 100 should
only be powered up following professional installation.
2 Application
The WAVESERIES signal conditioner PT 100 can be used to con-
nect PT 100 sensors as well as converting temperature data into
standard linear voltage signals. The temperature range can be set
by DIP switches on the printed circuit board.
3 Mounting and dismounting
Warning!! Mounting and dismounting may only be carried out
when the power supply has be disconnected. Failure
to observe will lead to considerable damage!
Comentarios a estos manuales