Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1 Manual de usuario descargar pdf (Pagina 97)

WI-I/O 9-L Configuration Manual

WI-I/O 9-L Wireless I/O page 97 of 108

Note

If the unit address of the module you are programming does not match the address of

the configuration that you are sending, WI Series shows the following warning:

This helps ensure that you program the correct module.

Check the module that you are programming should have its unit address changed. If

this is the correct module, click OK. If you have connected to the wrong module, click

Cancel to return to the previous screen and connect to the correct module and repeat

the programming operation.

7. WI Series writes the configuration information to the module.

8. Once configuration is complete, you should remove power and re-start the module to

enable the new configuration.

Note

If you are programming a module with manually-set analog calibration, and that module

has been set to factory configuration, WI Series lets you select between using the

factory analog calibration or retaining the manual analog calibration.

If the manual analog calibration contains values you want to use, click No to continue

using the manual calibration; otherwise click Yes to reload the factory calibrations or

click Cancel to return to the previous screen without configuring the module.

If you click Yes the manual analog calibration values will be overwritten and cannot be

recovered.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 107 108

Sin comentarios

Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1 Manual de usuario Pagina 97