Weidmuller WI-GTWY-9 Manual de usuario descargar pdf (Pagina 3)

Application Note WI-GTWY-9-DE1 DeviceNet Slave

Weidmuller

Page 3 of 16 App Note WI-GTWY-9-DE1 v1.1

WI-GTWY-9-DE1 Configuration via W-Series Configuration Software:

1. Setup MAC ID and baud rate:

The WI-GTWY-9-DE1 should be given a unique ‘MAC ID’ (i.e. node address) on the network –

allowable values are 1 – 63. Three different baud rates are available, the selection should match that

of the network. The screen shot above shows these settings in software. The WI-GTWY-9-DE1 also

provides an option for these settings to be applied via external DIP Switches, for further details refer

to the WI-GTWY-9-DE1 manual.

2. Network Configuration (Fieldbus Mappings):

I/O data from either the radio network or local I/O must be made available to the DeviceNet

network via fieldbus mappings in the WI-GTWY-9-DE1. Fieldbus mappings allow the flexible

allocation of I/O from the Radio Interface to an internal database (Fieldbus Interface) which is then

the connection point for I/O transferred over the DeviceNet Network. Details on configuring the

radio network can be found in the WI-GTWY-9-DE1 User Manual.

Referring to the block diagram provided in the summary section, we will first make the required

fieldbus mappings for the input data using fieldbus write mappings. Select New Fieldbus Mapping

under the ‘Fieldbus Config’ section to display the mapping screen shown below. In this example,

we use the word transfer mode to transfer 10 I/O registers (20 bytes) to the Fieldbus Interface IN

Area. The I/O Input Instance is selected as 1.

1 2 3 4 5 6 7 8 ... 15 16

Sin comentarios

Weidmuller WI-GTWY-9 Manual de usuario Pagina 3